BenQ RS232 Commands Manual de usuario descargar pdf (Pagina 32)

Additional information

English

Installing the cable connector-panel cover

The cable connector-panel cover is used to cover those unsightly cables and connections in the rear of the

projector after all of the cable connections have been done.

Important Notice: The following instructions are only for the projector which is intended to be installed

near the floor or in a reachable location. If your projector is ceiling-mounted or out of your reach, it is a

must to install or un-install the cable cover through a qualified technician’s help.

To install the cover:

1. Repeat Step 1~Step 3 in the "To clean the filter:"

section. See page 31 for details.

2. Place a soft item on the desk for padding. Turn the

projector upside-down so that you can locate the

screws that hold the rear cover to the projector on

both sides. Loosen the screws.

3. Turn the projector topside-up. Remove the rear

cover.

4. Manage all the connected cables within the

indentation of the cable connector-panel cover and

attach it to the projector securely.

5. Turn the projector over again. Tighten the screws

to hold the cable connector-panel cover and the

projector on both sides.

6. Re-install the filter cover securely.

7. The installation is finished.

W10000-en.book Page 32 Thursday, October 19, 2006 1:45 PM

1 2 ... 27 28 29 30 31 32 33 34 35 36

Sin comentarios

BenQ RS232 Commands Manual de usuario Pagina 32