BenQ MX726 Manual de usuario descargar pdf (Pagina 4)

Preparation4

Preparation

Your BenQ projector is equipped with the wired and/or wireless network function. You

can manage and control the projector from one or more remote computers using a web

browser when they are properly connected to the same local area network. You can also

sent the contents of your computer to the projector for projection using the QPresenter.

If your projector comes with a Quick Wireless NFC kit, you can also perform wireless

projection from your smart device or computer with just a few steps. Directly go to

"Wireless Projection (for selected models)" on page 27.

Connecting the projector with your computer

Wired connection

If you are in a DHCP environment:

1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector

and the other end to the RJ45 port on your Ethernet or router.

2. Do one of the following:

•Press NETWORK SETTING on the remote control. The Network

Settings page is displayed.

•Press MENU/EXIT and then press / until the SYSTEM SETUP:

Advanced menu is highlighted. Press to highlight Network Settings and

press MODE/ENTER. The Network Settings page is displayed.

3. Highlight Wired LAN and press MODE/ENTER.

4. Make sure the Status is Connect.

5. Press to highlight DHCP and press / to select On.

6. Press to highlight Apply and press MODE/ENTER.

7. Re-enter the Network Settings > Wired LAN page. The IP Address, Subnet

Mask, Default Gateway, and DNS settings will be displayed. Note down the IP

address displayed in the IP Address row.

If the IP Address still does not appear, contact your ITS administrator.

If you are in a non-DHCP environment:

1. Repeat steps 1-4 above.

Wired LAN

Laptop computer

Desktop computer

Projector

RJ45 cable

1 2 3 4 5 6 7 8 9 ... 32 33

Sin comentarios

BenQ MX726 Manual de usuario Pagina 4